-. Please install it in a place with low humidity and good ventilation

▲ Moisture or water-prone areas can cause rust or electric shock.

-. Do not install it in a place where the wind blows directly or near the heating device

▲ Please ensure that the cooling efficiency decreases rapidly and does not function properly, 

    and that the indoor temperature can be maintained below 27℃.

-. Please avoid direct sunlight

▲ It is not good for cooling efficiency and maintaining the life of the product.

-. Please install it on a strong and horizontal floor

▲ Unstable installation is caused by showcase noise.

-. Made for indoor use.

▲ It does not guarantee the performance of the product when installed outdoors.

Remove all moisture around the circuit breaker and insert the power cord by rotating it 180 degrees

Dew may occur in showcases or glass doors when the humidity of the installation site is high or the hot and humid weather continues during the rainy season.

Wipe it with a dry cloth or towel

If you try to reopen immediately after closing, it may not open or feel heavy.

This is because the air inside the chamber cools rapidly and changes the pressure inside the chamber.

In this case, do not overdo it and reopen it after 2-3 minutes.

If you try to open it too much, the handle may be damaged or injured.

1. The sound like water is flowing.

These are the sounds from the refrigerant in the compressor. It's not out of order, so use it with confidence.

2. When you feel the sound is too much,

Please check again whether the product installation floor is hard, whether the product is tilted, and whether the wall is in contact with the product

Direct-cooled refrigeration and refrigeration showcase are cooled using cold air on the wall, so due to the product characteristics

This may cause frost. Turn off the power and remove it after 1 hour.

Never use a sharp awl or knife.

Damage to the wall can cause failure.

1. Are you installing it outdoors and using it?

Our product is for indoor use. When using outdoors, it may cause degradation or failure of the product, so please use it indoors.

2. Please check if there are any heating materials around the product.

Remove heat and ventilate so that the indoor temperature can be maintained below 27℃

3. Please check the storage capacity.

If you put more than the right amount of planting in the chamber, the circulation of cold air can be weakened.

Please check the appropriate capacity and use it

4. Please check the gap between the back wall of the product.

If the product is installed in close contact with the wall, it may cause heat dissipation.

Make sure that both sides and back sides are at least 10 cm and the top side is at least 30 cm

5. Please check the condenser

If there is a lot of dust in the condenser, there is no ventilation and cooling is not good.

Please remove the dust from the condenser

Power plug is unplugged, switch is off, power failure, and

Please check if the short circuit breaker is down